Display driver
Location of the Display driver installer:
- x:\Drivers\Disp_driver (The letter ‘x’ means the drive letter of the CD-rom).
Installation
Follow instructions below.
1. Start SmartPad PC and login to the Windows®
2. Close SmartNav program if it runs
3. If “Welcome to the Found New Hardware Wizard” dialog opens then close it.
4. Place SmartNav installation CD to the CD-rom drive (if SmartNav installation window opens then click exit)
5. Open Windows® explorer and browse to the x:\Drivers\Disp_driver folder
6. Double click Setup.exe icon to start the driver installer
7. Click “NEXT”
8. Click “YES” and wait a moment until installation is completed
9. Click “FINISH” to re-start SmartPad PC
Un-installation
Follow instructions below.
1. Start SmartPad PC and login to the Windows®
2. Close SmartNav program if it runs
3. Select “START => CONTROL PANEL => PERFORMANCE AND MAINTENANCE => SYSTEM”.
4. Then select “HARDWARE tab and click “DEVICE MANAGER” button from the device manager.
5. Browse “Display Adapters” and expand it by selecting a “+” symbol on the left hand side of it
6. There are two graphic controllers under “Display Adapter”. Right click first one of the “Intel® 82852/82855...” graphic drivers and select “Un-install”.
8. Click “YES”
9. Re-start SmartPad PC
10. Perform steps from 1 to 5
11. Right click remaining graphic driver under “display adapters” and select “Un-install”
12. Click “OK”
13. Click “YES”
14. Re-start SmartPad PC
Reinstallation
Updating the Display driver requires the un-installation of exist driver first and then new installation is allowed. Follow the Un-installation and Installation sections above to do that.